Insignia NS-F20TV Television

5

Press

or

to enter the Auto Program sub

Checking DTV signal strength

 

menu.

 

 

 

You can check the strength of your DTV signal

6

Press

or

to select ANTENNA.

and determine whether you need to adjust your

 

 

 

 

 

 

antenna or digital cable input. The stronger the

 

 

 

 

 

 

signal strength, the less likely you are to

 

 

 

 

 

 

experience picture degradation.

 

 

 

 

 

 

To check DTV signal strength:

 

 

 

 

 

 

 

 

 

 

 

 

1 Go to the Preset menu.

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

7 Press or to select AIR or CABLE.

In AIR mode, the television receives antenna signals. In CABLE mode the television receives cable television programs. Select:

•AIR—If using a VHF/UHF antenna.

•CABLE—If using cable television or a satellite dish. If you have any questions about these settings, contact your dealer.

2Press or to select CH SETUP.

3Press or to enter the CH SETUP menu.

8Press to select START.

9Press or to start Auto Program.

The television begins to search and memorize all available programs. It may take a few minutes to finish searching.

Note

The television first memorizes analog programs. After all available analog programs have been memorized, it begins to memorize DTV programs. During analog program memorizing, you can press MENU to stop the process. The television then starts memorizing DTV programs. If you want to stop DTV program memorizing, press MENU again.

Skipping unwanted channels

After saving channels into memory, you can skip unwanted channels so that only the channels you want to watch are selected with the CH+/- buttons.

To skip unwanted channels:

1Go to the Preset menu.

The bottom line on the CH SETUP menu shows the signal strength for the current DTV channel.

Selecting channels

You can use one of three methods to select a channel:

•Use the number pad.

•Use the CH+ and CH- buttons.

•Use the previous channel button.

Using the number pad

To go to a specific channel number:

•Press the number buttons (0-9) and the dash (-) button, then wait for the television to change channels, or press ENTER to go immediately to that channel.

For example, if you want to select channel 8-3, press 8-3 on the remote control. (Make sure that you press the buttons within three seconds of each other, or the channel won’t be entered correctly.)

2Press or to select CH SETUP.

3Press or to enter the CH SETUP menu.

4Press or to select CH NO.

5Press or to select a channel number.

6Press to select SKIP.

7Press or to select ON.

The channel will be skipped when you browse through channels using the CH+/- buttons.

Note

In some situations, virtual channel numbers do not correspond to physical frequencies.

Using the CH+ and CH- buttons

To browse through the channels:

•Press:

•CH+ to browse up the channels.

•CH- to browse down the channels.

Using the previous channel button

To switch between two channels:

•Press the previous channel button to switch between the current channel and the previous channel.

Tip

To restore a skipped channel, use the number buttons to select the skipped channel, then repeat the previous steps and set SKIP to OFF.

www.insignia-products.com

11