|
| Insignia |
Back panel of typical | Cable TV | To set the home theater system’s RF output |
cable box | wall jack | channel: |
1 While the home theater system is turned off, press and hold CH/PRESET
Back of home theater system
Connecting the home theater system to the television
Connect the home theater system to your television using one of the following methods:
•“RF coaxial connection” on page 8
•“Audio/Video connection” on page 8
•“Component Video (ColorStream®) connection” on page 8
•“Progressive Scan (ColorStream® pro) connection” on page 9
RF coaxial connection
Connect the ANTENNA/CABLE OUT jack on the home theater system to the ANTENNA in jack on the television using the
2Press CH/PRESET
3Turn the home theater system off, then turn it on again.
4Select the television’s CH to 3 or 4 depending on the RF output channel you selected.
Audio/Video connection
To connect the home theater system to the television using the A/V jacks:
1Connect the home theater system VIDEO OUT jack on the home theater system to the video in jack on the television using the supplied video cable.
Video
Audio
Coaxial cable
Back of home theater system
Back of home theater system
Note
If you use this connection, tune the television to the home theater system’s RF output channel (CH 3 or 4).
2Connect the left and right home theater system AUDIO OUT jacks on the home theater system to the audio left/right in jacks on the television using the supplied audio cables.
Note
If you use this connection, set the television’s source selector to VIDEO.
Component Video (ColorStream®) connection
Note
DVD playback can also be done using the COMPONENT/ PROGRESSIVE SCAN VIDEO OUT connection. The tuner and VCR only output through the RF.OUT (R) or home theater system OUT (A, V) jack.
8 |