![](/images/backgrounds/182360/182360-6039x1.png)
3Enter 9 7 5. The LED blinks twice.
Note
If more than 10 seconds pass between key presses, the remote exits programming.
If the LED displays one long flash instead, either your batteries are low, or the Insignia remote control has a memory fault. In either case, the remote cannot learn a new key.
4Press the key on the remote you wish to program. The feedback LED stays lit for three seconds, indicating that the remote is ready to learn.
5On the original remote, press and hold the key to be learned. Continue holding the key on the original remote until the Insignia’s LED blinks twice.
Note
If the red LED displays one long blink, a learning error has occurred. Try repeating this step again until a successful capture occurs. If the function is still not captured, press and hold SET to exit programming and review the Precautions” above. If needed, also see “Troubleshooting remote control programming” on page 37. After reviewing, start programming again at Step 1.
6Repeat Steps 4 and 5 to program another key. Once you have completed programming all the keys you want, press and hold SET until the LED blinks twice to save all data learned.
Deleting a single learning keyThis process returns the key to its original programming for the mode you select. You can also delete learned programming by teaching a different function to the key (see “Programming a Learned Key” above).
Note
If more than 10 seconds pass between key presses, the remote exits programming.
If the LED displays one long flash instead, either your batteries are low, or the Insignia remote control has a memory fault. In either case, the remote cannot learn a new key.
To delete a single learned key:1Press the mode key that you wish to remove the learned key from.
2Press and hold SET until the LED blinks twice, then release.
3Enter 9 7 6. The LED blinks twice.
4Press the key containing the learned function to be deleted, twice. The LED blinks twice and programming ends.
Note
If more than 10 seconds pass between key presses, the remote exits programming.
If the LED displays one long flash instead, either your batteries are low, or the Insignia remote control has a memory fault. In either case, the remote cannot learn a new key.
To delete all learned keys in a specific mode:1Press and hold SET until the LED blinks twice, then release.
2Press 9 7 6. The LED blinks twice.
3Press a mode key twice (for example, TV, DVD, STB, or AUX) to clear all the learned keys for that mode. The LED blinks twice and programming ends.
Changing volume lockThe Insignia universal remote control comes preset to allow independent volume control of each selected device (global volume unlock). However, you may change the volume lock setting to global volume lock so that one device's volume controls volume in all other modes. After that, you can perform Individual volume unlock on a selected device to set its volume control for independent operation or global volume unlock to remove all volume locking.
To lock volume control to one mode (global volume lock):1Press and hold SET until the red LED blinks twice, then release.
2Enter 9 9 3, the LED blinks twice.
3Press the mode key for the device you want to control (for example, TV).
4The LED blinks twice. Now when you press VOL+,
1Press and hold SET until the red LED blinks twice, then release.
2Enter 9 9 3, the LED blinks twice.
3Press VOL+. The LED blinks four times. Volume is independently controlled for all programmed devices.
To unlock a single device’s volume control:1Press the desired device mode key (TV, DVD, STB, or AUX).
2Press and hold SET until the red LED blinks twice, then release.
3Enter 9 9 3. The LED blinks twice.
4Press
www.insigniaproducts.com | 35 |