Insignia NS-R2001 Recording

Insignia NS-R2001 AM/FM Stereo Receiver

www.insigniaproducts.com

Scanning preset stations in sequence

To scan preset stations:

1Press the PRESET button on the remote control.

The receiver starts scanning the stations in the

preset sequence. Each station is sampled for five

seconds.

2Press the PRESET button again to stop

scanning.

Listening to FM stereo broadcasts

To listen to FM stereo broadcasts:

• While listening to an FM broadcast, press the

MO/ST button. Each time this button is pressed,

the FM mode changes as follows:

•Stereo mode—ST lights up.

•Mono mode—ST turns off.

Recording

Use your stereo receiver as a switch to connect your

audio sources to the audio recording device that is

connected to AUX 1 OUT (for example, a tape

deck). You can record audio from your CD, Phono, or

AUX 2 device to the audio recording device. You can

also record a CD, Phono, or AUX 1 audio source if

your audio recording device is connected to AUX 2

OUT.

Recording on AUX 1

To record on AUX 1:

1Select the recording input source (this cannot

be AUX 1).

2Start recording on the AUX 1 device.

3Start play on your input device to provide the

audio signal to record.

Recording on AUX 2

To record on AUX 2:

1Select the recording input source (this cannot

be AUX 2).

Note

Stations with weak signals will not be scanned, and

will therefore not be sampled.

Notes

• The volume, tone (bass and treble), and balance

settings have no effect on the recording signals.

• When you select the tuner, CD, or PHONO as a

recording source, recording may be made on

AUX 1, or AUX 2, or both simultaneously.