InSinkErator AS-101K-3 Wiring Diagram, 208/230 3-phase 1/2 to 10 HP, Electrical Shock

AS-101K-3 Wiring Diagram

ELECTRICAL SHOCK

•Turn off the electrical supply to the disposer before attempting any work on it. Use a voltmeter or circuit tester to ensure that power is off.

•Installation must conform to local electrical codes.

•All control centers and disposers must be carefully and permanently grounded.

•A properly fused disconnect must be installed at the electrical supply source for the control center.

PROPERTY DAMAGE

•Ensure that the control center voltage and phase match the disposer motor and electrical supply. Check nameplates on disposers and control centers for voltage and phase specification.

•The disposer motor wiring connection is shown in the disposer terminal box.

208/230 V

3-phase

1/2 to 10 HP

							9
						12
					11
					6
		M2	M3		6
											6
	M1
														AC CURRENT
	4
		4					4	4						SENSOR
												L2					L2
														TRIP
														DELAY
															1		4
																	7
															2
														TRIP			14
														POINT	3
															4		7
															5
					10
	L1	L2	L3
										10
			9	7	7						7
											7
					WATER
					SHUTOFF
					DELAY
														H1	H3	H2	H4
		PRINTED
		CIRCUIT												X2		XF
		BOARD
																FUSE
	7					4								4
	11	12	13		2
															GROUND
																	(FNA2)
																2
														4
6	6														L1	L2	L3
	6
																ON
STOP	START	2	3		4	6	7	7	13	14	NC	M1	M2	M3	OFF
3	7						24V WATER					M1		M3
							SOLENOID VALVE
							MOUNT IN LINE								L1	L2	L3
							1 GPM
							FLOW CONTROL						M2
																	PANEL
																	GROUND
													DISPOSER				LUG

Call Toll Free 1-800-845-8345 for the nearest InSinkErator Authorized Service Agency or to reach Technical Support.

24V WATER	MOTOR
SOLENOID VALVE
MOUNT IN LINE
7 GPM
FLOW CONTROL

INCOMING POWER

11