InSinkErator AS-101K-1 Wiring Diagram, phase, 1/2 to 2 HP, Electrical Shock, Property Damage

AS-101K-1 Wiring Diagram

ELECTRICAL SHOCK

•Turn off the electrical supply to the disposer before attempting any work on it. Use a voltmeter or circuit tester to ensure that power is off.

•Installation must conform to local electrical codes.

•All control centers and disposers must be carefully and permanently grounded.

•A properly fused disconnect must be installed at the electrical supply source for the control center.

PROPERTY DAMAGE

•Ensure that the control center voltage and phase match the disposer motor and electrical supply. Check nameplates on disposers and control centers for voltage and phase specification.

•The disposer motor wiring connection is shown in the disposer terminal box.

								4
						12	9
		M7						4
			M1
120 V		4	4
	6	6											6					AC CURRENT
1-phase															L2			SENSOR					L2
1/2 to 2 HP		M7		M4M4	M6
						11
																		TRIP
																		DELAY
																					1		4
																							7
					M5																2
																		TRIP					14
						10												POINT			3
																					4
			L2	M2																		7
	7	7										7	7								5
		L1
												10
					9
						WATER
						SHUTOFF
						DELAY
																			H1	H3	H2	H4
				PRINTED
				CIRCUIT
				BOARD
																			X2		XF
		7					4														FUSE
			11	12	13	2
																		4
																			4			(FNA2)
																				GROUND
																					2
																						L1	L2
																							ON
6	6	6																				OFF
					2	3	4	6	7	7	13	14	M1		M2		M4	M5	M7	NC	NC
STOP		START											M3				M6
																						L1	L2
													1	3	2	4	6	5	7
3	7

	24V WATER
	SOLENOID VALVE		INCOMING
	MOUNT IN LINE		POWER
	1 GPM
Call Toll Free 1-800-845-8345	FLOW CONTROL	DISPOSER	PANEL
	24V WATER	MOTOR	GROUND
for the nearest InSinkErator			LUG
	SOLENOID VALVE
Authorized Service Agency or	MOUNT IN LINE
	FLOW CONTROL
	7X GPM

to reach Technical Support.

9