InSinkErator AS-101K-4 Wiring Diagram, 380/460 3-phase 1/2 to 10 HP, Electrical Shock

AS-101K-4 Wiring Diagram

ELECTRICAL SHOCK

•Turn off the electrical supply to the disposer before attempting any work on it. Use a voltmeter or circuit tester to ensure that power is off.

•Installation must conform to local electrical codes.

•All control centers and disposers must be carefully and permanently grounded.

•A properly fused disconnect must be installed at the electrical supply source for the control center.

PROPERTY DAMAGE

•Ensure that the control center voltage and phase match the disposer motor and electrical supply. Check nameplates on disposers and control centers for voltage and phase specification.

•The disposer motor wiring connection is shown in the disposer terminal box.

							9
						12
					11
					6
		M2	M3		6
											6
	M1
														AC CURRENT
	4
		4						4						SENSOR
							4					L2					L2
														TRIP
														DELAY
															1		4
																	7
															2
														TRIP			14
														POINT	3
															4		7
															5
					10
	L1	L2	L3
										10
			9	7	7						7
											7
					WATER
					SHUTOFF
					DELAY
														H1	H3	H2	H4
		PRINTED
		CIRCUIT												X2		XF
		BOARD
																FUSE
	7					4								4
	11	12	13		2
															GROUND
																	(FNA2)
																2
														4
6	6														L1	L2	L3
	6
																ON
STOP	START	2	3		4	6	7	7	13	14	NC	M1	M2	M3
															OFF
3	7											M1		M3

	24V WATER
	SOLENOID VALVE		L1 L2	L3
	MOUNT IN LINE
	1 GPM	M2		PANEL
	FLOW CONTROL
				GROUND
Call Toll Free 1-800-845-8345		DISPOSER		LUG
	24V WATER	MOTOR	INCOMING
	SOLENOID VALVE
for the nearest InSinkErator	MOUNT IN LINE		POWER
	7 GPM
	FLOW CONTROL
Authorized Service Agency or
to reach Technical Support.

380/460 V

3-phase

1/2 to 10 HP

12