InStep QE100A manual 12B. Hold the lever and pull the axle skewer with spring out

STEP 12 Coupler attachment for bikes with quick-release rear axles. (Note: If your rear bike tire has two hub nuts please refer to Steps 10 & 11.)

12A

12B

12C

12D

12A. Flip open the quick-release lever, and remove the nut and spring from the opposite side.

12B. Hold the lever and pull the axle skewer with spring out.

12C. Completely remove the skewer but leave the wheel in place.

12D. Slide the coupler plate and tab washer onto the skewer. IMPORTANT! The wide end of the spring should face out and touch the lever, the bell of the coupler plate should face out, and the tab washer hook should face in toward the wheel hub.

STEP 13 Attach trailer tow bar to bike

13A

13B

13C

13D

13A. Insert end of skewer through wheel hub and fit tab washer hook into slot in bike frame dropout.

13B. Replace the spring (wide end out) over the end of the skewer, followed by the nut. Tighten the nut by hand and clamp the lever down (F).

13C. Insert the end of the trailer tow bar into the large hole and fasten the Q/R pin.

13D. IMPORTANT! Loop the safety strap around the bike frame and clip the end into the “D” ring at the end of the tow bar (H).

WARNING Safety strap must attach to the bike frame when using this product in trailer mode.

7