Operations
LISTENING TO A PROGRAM SOURCE
Before operation
∙Push the POWER switch.
• This unit enters the standby mode and the STANDBY indicator lights up.
This means that the receiver is not disconnected from the AC mains and a small amount of current is retained to support the operation readiness.
• To switch the power off, push the POWER switch again. Then the power is cut off and the STANDBY indicator turns off.
1. In the standby mode, turn the power on.
• Each time the ON/STANDBY button on the front panel, the receiver is turned on to enter the operating mode or off to enter the standby mode.
• On the remote control, press the POWER ON button to enter the operating mode or press the STANDBY button to enter the standby mode.
2. Switch the desired speakers on.
• You can select the various combinations of speakers depending on where the speakers C or/ and D are installed.
• Each time the SPEAKER A/B SELECTOR button is pressed, the speakers are switched on or off as follows :
� A/B ~ �
or (MAIN A/B) or (MAIN
( ) : When the ROOM2 mode is set to on.
• Each time the SPEAKER C/D SELECTOR button is pressed, the speakers are switched on or off as
| follows : |
|
|
|
|
| � ~ C/D � | ~ | � ~ C/ - | � ~ |
|
|
| ||||
| or (R2 C/D) | or (R2 | or (R2 | or (R2 | |
|
|
|
|
|
|
( ) : When the ROOM2 mode is set to on.
• When using the headphones for private listening, switch off all the speakers installed in the main room.
�Note :
• To use ROOM2 function, you should install speakers C or/and D in another room (ROOM2) and set the ROOM2 mode to on. (For details, refer to "CONNECTING SPEAKERS" on page 6 and "ROOM2 PLAYBACK" on page 21.)
10
