Integra Complete Guide to Connecting Your CDC 3.4 CD Player

System Connections

•Do not plug in the power cord until all connections have been made.

•On each pair of input or output jacks, the jack marked R corresponds to the right channel and the jack marked L corresponds to the left channel.

AC INLET

	WARNING	AVIS
	RISK OF ELECTRIC SHOCK	RISQUE DE CHOC ELECTRIQUE
	DO NOT OPEN	NE PAS OUVRIR
				COMPACT DISC CHANGER
				MODEL NO. CDC-3
				RATING:
ANALOG		REMOTE	DIGITAL	AC120V 60Hz 10W
OUTPUT		CONTROL	OUTPUT

	2-1, NISSHIN - CHO, NEYAGAWA- SHI, OSAKA,
OPTICAL	JAPAN MANUFACTURED IN MALAYSIA
L
R

	Audio
	connection cable			To wall
	cable	Optical fiber cable		outlet
L	R	(not included)
			Connecting a power cable
	CD	Optical IN	1.	Connect the outlet plug on the included power
		DAT, MD recorder or		cable to the AC INLET on the CDC-3.
	Amplifier		2.	Plug-in the other end of the cable to a wall AC
		Digital amplifier
				outlet.
			Note:
			•	Do not use any power cable other than the included
				cable. The included cable is designed for use only
			•	with the CDC-3. Do not use it for any other device.
				Do not connect or disconnect the outlet plug from

the CDC-3 while the other end is plugged into the wall AC outlet.

Connecting to an audio system

Two types of output jacks are located on the rear panel.

Use the DIGITAL OUTPUT jack if you are connecting the unit to audio equipment that supports a digital connection.

ANALOG OUTPUT jacks:

These are the most commonly used jacks. Connect these jacks to the amplifier’s CD input jacks using the supplied audio connection cable.

DIGITAL OUTPUT (optical output) jack:

For digital recording, connect this jack to the digital input jack of a Mini Disc recorder, a DAT deck, or other digital equipment. If your amplifier has a digital input jack, connecting the DIGITAL OUT- PUT jack to it will produce a much clearer and more dynamic sound.

•Terminal protection cap is attached to the digital jack.

Remove the cap when connecting the unit to other digital equip- ment. When you are not using the digital output jack, replace the cap.

•Refer to the amplifier’s instruction manual for connections.

Connections for remote controller ()

When connecting Onkyo/Integra products, it is necessary to attach

the cable to be able to use the remote controller of the main component to control the entire system.

1.To use this CD changer with an amplifier (or receiver), cassette

tape deck, and tuner that include the appropriate jack, con-

nect the components using the cable, plugged into the REMOTE CONTROL jacks.

2.As the exact connection sequence of the cable is unimpor- tant, you can connect from the amplifier (or receiver) to either the

tuner, cassette tape deck, or compact disc changer.

3.To operate correctly, the remote controller must point toward the remote control sensor of the amplifier (or receiver).

Notes:

•The upper and lower REMOTE CONTROL jacks have the same function.

•Remote controller operation is not possible when only the cable is connected – the audio connection cables must also be

connected.

•An cable equipped with a 3.5mm (1/8 in.) diameter minia- ture two-conductor phone plug is included with this unit and

with every tuner and cassette tape deck that utilizes the jack.

6

1

To AC outlet

2

POWER

ON OFF

Connecting the power

Before plugging in the unit, confirm that all connections have been made properly.

1. Insert the AC power supply cord into the outlet.

2. Press the POWER button.

•When the power first turns on, the carousel rotates to find a disc and stops automatically if there is a disc on the disc tray.