Integra DTA-70.1 Front & Rear Panels-Continued, e f g a b c d, aBalanced Input XLR terminal

Models: DTA-70.1

1 20
Download 20 pages 32.3 Kb
Page 9
Image 9
Front & Rear Panels—Continued

DTA-70.1_En_100108.book Page 9 Friday, January 8, 2010 2:04 PM

Front & Rear Panels—Continued

Rear Panel

This unit comprises 9 independent power amplifiers, each being capable of reproducing the same quality sound through its channel. Note that you should connect an input source and a speaker to each channel in use.

Caution

Do not connect the power cord until you have finished all other connections.

Read the instructions that came with the other components you are connecting.

Do not make connections to input or output jacks while the amplifier is turned on (Power Rear Panel On).

Turn the volume of the control amplifier down before turning on the amplifier.

e f g

a

b c

d

aBalanced Input (XLR terminal)

Connect AV controllers or control amplifiers with balanced outputs for high-quality sound.

1. GND

1

3

3. COLD

2

2. HOT

Connector ground terminal: Chassis grounded

The pin assignments for this terminal are given above. This pin assignment conforms to the stan- dard adopted by the Audio Engineering Society. Refer to the instruction manual supplied with the control amplifier and verify that its output terminal is compatible with the pin assignments for this ter- minal. The output terminal of Integra DTC-80.1 is compatible with the pin assignments for the termi- nal of the amplifier.

The amplifier uses the European type XLR termi- nal. Phase is reversed when an XLR cable is con- nected to the control amplifier that uses the USA type XLR terminal. In this case, swap pin 2 and pin 3 to set the polarity to the European type before connecting.

h

Plugging the XLR cable

Match the pins and insert the terminal until you hear a “click.” Make sure that the terminal is locked by lightly pulling the connection cable.

Unpugging the XLR cable

Pull out the connection cable while holding down the lever.

Push

Notes:

When using this balanced connection for a specific channel between the control amplifier and the ampli- fier, set the INPUT SELECT switch to the upper side (the balanced input side) to select balanced input. Next, use commercial XLR balanced cable and con- nect the balanced output from the control amplifier to the corresponding balanced input on the amplifier.

Do not connect anything to the RCA-type audio input jack.

9

Page 9
Image 9
Integra DTA-70.1 Front & Rear Panels-Continued, e f g a b c d, aBalanced Input XLR terminal, Plugging the XLR cable