Intel 520T manual Mounting screws are not provided because the required sizes, Vided

C H A P T E R 1 Intel Express 520T Switch

	• Customer-supplied screws for securing the switch in the rack.
	Mounting screws are not provided because the required sizes
	may vary from rack to rack.
In an equipment rack	To mount the switch in a standard equipment rack:
	1 Attach the mounting bracket marked “Left” to the left-hand side
	of the switch, and attach the mounting bracket marked “Right”
	to the right-hand side of the switch, using the four screws pro-
	vided.

Slot A Slot B

1 2 3 4 5 6 7 8 9 10 11 12

LEDs	Green	Orange
Off	10 Mbps	Half duplex	®
Solid	100 Mbps	Full duplex	Intel Express
	Port Status		520T Switch
			Status	Power
LEDs	Green	Orange	Temperature	Reset
Solid	Link	Disable	RPS
Blink	Activity	Collision
				Console
				9600-8-N-1

1734

Make sure that you attach the mounting brackets to the correct sides. Otherwise the switch will not align correctly in the equipment rack.

	2	If the four rubber feet prevent the switch from standing firmly
		on the equipment rack’s side support rails, remove them.
	3	Set the switch in the equipment rack, and make sure there is
		adequate space for air flow around the switch (see “Allow ade-
		quate ventilation” in “Positioning and Installing the Switch”, p.
		7).
	4	Screw the mounting brackets securely to the equipment rack.
Ambient temperature	If the switch is installed in a closed or multi-rack assembly, the oper-
	ating ambient temperature of the rack environment may be greater
	than the ambient temperature of the room. Make sure that the temper-
	ature of the rack environment does not exceed the recommended op-
	erating temperature for the switch.

8