Quick Start
3 Install the Router in
Intel Device View
The Device Install Wizard sets up the router for management in Intel Device View by performing basic configuration, such as assigning an IP address.
1If it is not already running, start the Device Install Wizard by selecting Install from the Device menu (see Figure 5).
2Click Next.
3When the router’s MAC address appears (see Figure 6), select it and click Next. The MAC address is on the label near the LAN port on the back of the router.
Note The MAC address appears only for routers with a factory default IP address (as indicated by the Status LED blinking green). If the router has already been assigned an IP address, select Manage from the Device menu and enter the router’s IP address. You can also reset the router to the factory default settings (see the instructions below).
4Assign the router’s IP address (see Figure 7), then follow the Device Install Wizard screen instructions. The router’s default IP address is 192.0.2.1. We recommend that you do not use the default address as your router’s IP address.
5On the Device Install Wizard - Finish screen, select “Configure the device,” then follow the screen instructions.
To reset the router to factory defaults:
1Press the Recovery button located on the back of the router. After a few seconds the Status LED blinks orange.
2Press and hold the Recovery button until the LEDs begin to blink in sequence. When the Status LED blinks green, the router is set to factory default.
Figure 5. Start the Device Install Wizard. Select Install from the Device menu to start the Wizard.
Figure 6. Select the MAC Address. If the router’s MAC address does not appear, check the LAN connection and verify that the router is set to factory defaults, as shown by a blinking green Status LED.
Figure 7. Assign an IP address. Type the IP address and subnet mask for the router.
4
