Intel Desktop Board DH57JG Product Guide
9.When the DIMM is inserted, push down on the top edge of the DIMM until the retaining clips snap into place. Make sure the clips are firmly in place.
10.Reinstall the PCI Express graphics card if one was removed in Step 4.
11.Replace the computer’s cover and reconnect the AC power cord.
Removing DIMMs
To remove a DIMM, follow these steps:
1.Observe the precautions in "Before You Begin" on page 27.
2.Turn off all peripheral devices connected to the computer. Turn off the computer.
3.Remove the AC power cord from the computer.
4.Remove the computer’s cover.
5.If a full length PCI Express graphics card is installed in the PCI Express x16 connector, remove the card to gain access to the DIMMs.
6.Gently spread the retaining clips at each end of the DIMM socket. The DIMM pops out of the socket.
7.Hold the DIMM by the edges, lift it away from the socket, and store it in an
8.Reinstall the PCI Express graphics card if one was removed in Step 5 and reconnect any other parts you removed or disconnected to reach the DIMMs.
9.Replace the computer’s cover and reconnect the AC power cord.
Installing and Removing PCI Express x16 Graphics Cards
Installing a PCI Express x16 Graphics Card
CAUTION
Before installing a PCI Express x16 graphics card, make sure that the tabs on the DIMM sockets are in the upright position (closed); otherwise, they may be damaged by the PCI Express card during installation.
CAUTION
When installing a PCI Express card, ensure that the card is fully seated in the PCI Express connector before you power on the system. If the card is not fully seated in the connector, an electrical short may result across the connector pins. Depending on the
40
