Installing and Replacing Desktop Board Components

Installing the Desktop Board

Refer to your chassis manual for instructions on installing the desktop board. The desktop board is secured to the chassis by seven screws. Figure 10 shows the locations of the mounting screw holes.

✏NOTES

You will need a Phillips (#2 bit) screwdriver.

Refer to Appendix B for regulatory requirements and installation instructions and precautions.

WARNING

Only qualified technical personnel should attempt this procedure. Disconnect the computer from its power source before performing the procedures described here. Failure to disconnect the power before you open the computer can result in personal injury or equipment damage.

OM10093

Figure 10. Location of the Mounting Screw Holes

31