FAN Duct Removal and Installation | Intel GS-SR168 specification

Hardware Installation Process

Step 3-7: FAN Duct Removal and Installation

Step 1 Pull up the screw-holder and lossen the thumbscrews. Lift up to remove the fan duct.

Step 2 For FAN Duct Installation, place the fan duct on the top of heat sinks. Fasten the screws to the locked position and push down the screw-holders.

Step 1

Step 2

1 7

Image 17

Intel GS-SR168 manual FAN Duct Removal and Installation

Contents

System Installation Guide Table of Content Security Server Precaution for Product with Laser Devices Safety, Care and Regulatory InformationImportant safety information FCC part 68 applicable to products fitted with USA modems Federal Communications Commission FCC Statement Canadian Department of Communications Compliance Statement Page Introduction Contents Packages Processor Supported Features Summary Super I/O System Overview Step System Hardware InstallationChassis Removal and Installation Pin1 indicator CPU Installation Memory Installation Heat Sink Installation PCI Expansion Card Installation Hard Disk Drive Installation FAN Duct Removal and Installation Front View of GS-SR168 Appearance of GS-SR168 Rear View of GS-SR168 Hg f e Back Plane Borad Layout Introduction NMI Switch and LED Indicators Introduction Name Color Condition Description LAN LED Description Connector Icon Description GA-9IVDPL Motherboard Layout Motherboard Layout & Jumper Setting Clrcmos Clear Cmos Function Jumper Setting Controlkeys Bios Setup Boot Status Page Setup Menu / Option Page Setup MenuMainMenu Main System Date System Time Bit I/O SystemInformation About This Section Advanced Advanced Onboard VGA Control PCI ConfigurationOnboard LAN Control Option ROM Scan Legacy USB Support Advanced Chipset ControlUSB Controller PCI-E portA Device Force Compliance Mode4GB PCI HoleGranularity Wake On LAN Set Max Ext Cpuid = Advanced Processor OptionHyper Threading Technology Serial Port a Peripheral Configuration Floppy disk controller Serial Port BFloppy Check Parallel ATA NativeModeOperation SATARAIDEnableSerial ATA Extended MemoryTesting Reset ConfigurationDataClk Gen Spread Spectrum System After AC Back Hardware Monitor CPU 1&2/Backboard 1/2/3 Temperature About This Section Security Set Supervisor Password Password on boot Set User Password Console Redirection Server Baud Rate Com PortAddressConsole Type FlowControl HaltOn Memory RAS Feature ControlClear Mem. ECC Error Info Boot Device Priority About This Section Boot About This Section Exit Exit Exit Discarding Changes Load SettupDefaultExit Saving Changes Save Changes Discard Changes Acronyms Appendix Ioapic