P4D/P4D-N Motherboard

AGP Aperture Setting You can set the AGP aperture size in the Advanced Chipset Features section of the CMOS Setup Utility

Installing an AGP Card

The AGP connector on the board supports AGP 4X 1.5- volt display cards. Follow the instructions that come with the display card for installing the card hardware in the AGP slot.

AGP Configuration

You can configure the amount of system memory the AGP card will use as auxiliary memory by adjusting the AGP Aperture Size setting in the Advanced Chipset Features section of the CMOS Setup Utility. The default aperture setting is 64MB the maximum is 256MB.

Display Drivers

You should install the display card’s display driver software according to the instructions that come with the card after you have completed system assembly and have installed an OS and the support software for this motherboard.

5•2

User’s Manual