Onboard IDE Connectors

Each channel connector supports one IDE channel with two drives, a Master and a Slave. The Master drive connects to the connector on the end of the ribbon cable. The Slave drive connects to the connector in the middle of the ribbon cable.

Note:

The ribbon cable used must support the transfer mode of the fastest device connected to it to avoid degraded performance.

Floppy Drive Connector

The floppy drive connector supports two floppy disk drives. The first drive, Drive A:, connects to the connector on the end of the floppy drive connector cable. A second drive, Drive B:, would connect to the middle connector on the cable although systems now commonly only have one floppy disk drive.

User’s Manual

5: System Configuration

JP6

J39

 

 

CPU

 

mPGA478B

 

 

 

 

 

 

ATX PWR

 

 

Intel i845

 

 

 

J79

 

J9

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

11V.

 

 

AGP

 

 

 

NDP4-

 

RTL8100B

 

 

 

 

 

 

 

 

J40

 

 

 

PCI1

 

 

 

 

 

 

 

 

IDE1

 

 

 

 

PCI2

nti

IDE0

 

 

 

 

 

 

 

 

 

 

el

 

+

J41

JP10

 

PCI3

 

BT1

 

 

 

 

 

 

 

 

 

JP1

 

 

 

 

PCI4

 

FDD

 

 

 

 

 

 

 

 

 

 

PCI5

FH73638W

JP16

 

 

 

 

 

 

 

JP12

 

 

 

 

 

 

J45

J66

J67

PCI6

J78

J65

Front Panel

 

J75

 

 

 

 

 

 

 

 

SMB1

IDE Primary Channel

Floppy connectorIDE Secondary Channel

5•5