Hardware Installations and Upgrades
Installing a PCI, PCI-X, or PCI-Express* Add-in Card
Add-in cards are not included with your system and must be purchased separately. This server
board requires the use of a riser bracket assembly with one or more riser connectors installed on it
in order to use a PCI, PCI-X, or PCI-Express add-in card. The riser assembly is typically included
with your server chassis. You may need to order the riser connector(s) separately, depending on the
server chassis.
See your server chassis documentation for additional requirements and for instructions on installing
an add-in card into a riser connector and then installing the assembly into the chassis.
Replacing the Backup Battery
The lithium battery on the server board powers the RTC for up to four to five years in the absence
of power. When the battery starts to weaken, it loses voltage, and the server settings stored in
CMOS RAM in the RTC (for example, the date and time) may be wrong. Contact your customer
service representative or dealer for a list of approved devices.

WARNING

Danger of explosion if battery is incorrectly replaced. Replace only with
the same or equivalent type recommended by the equipment
manufacturer. Discard used batteries according to manufacturer’s
instructions.

ADVARSEL!

Lithiumbatteri - Eksplosionsfare ved fejlagtig håndtering. Udskiftning
må kun ske med batteri af samme fabrikat og type. Levér det brugte
batteri tilbage til leverandøren.
ADVARSEL
Lithiumbatteri - Eksplosjonsfare. Ved utskifting benyttes kun batteri
som anbefalt av apparatfabrikanten. Brukt batteri returneres
apparatleverandøren.
VARNING
Explosionsfara vid felaktigt batteribyte. Använd samma batterityp eller
en ekvivalent typ som rekommenderas av apparattillverkaren. Kassera
använt batteri enligt fabrikantens instruktion.
32