Intel SEBFCM4 manual Handling electrostatic discharge-sensitive devices, Viii

Handling electrostatic discharge-sensitive devices

Any computer part containing transistors or integrated circuits (IC) should be considered sensitive to electrostatic discharge (ESD). ESD damage can occur when there is a difference in charge between objects. Protect against ESD damage by equalizing the charge so that the server, the part, the work mat, and the person handling the part are all at the same charge.

Note: Use product-specific ESD procedures when they exceed the requirements noted here.

Make sure that the ESD-protective devices you use have been certified (ISO 9000) as fully effective.

When handling ESD-sensitive parts:

•Keep the parts in protective packages until they are inserted into the product.

•Avoid contact with other people.

•Wear a grounded wrist strap against your skin to eliminate static on your body.

•Prevent the part from touching your clothing. Most clothing is insulative and retains a charge even when you are wearing a wrist strap.

•Use the black side of a grounded work mat to provide a static-free work surface. The mat is especially useful when handling ESD-sensitive devices.

•Select a grounding system, such as those in the following list, to provide protection that meets the specific service requirement.

—Attach the ESD ground clip to any frame ground, ground braid, or green-wire ground.

—Use an ESD common ground or reference point when working on a double-insulated or battery- operated system. You can use coax or connector-outside shells on these systems.

—Use the round ground-prong of the AC plug on AC-operated computers.

✏NOTE

The use of a grounding system is desirable but not required to protect against ESD damage.

DANGER

Electrical current from power, telephone and communication cables is hazardous.

To avoid a shock hazard:

•Do not connect or disconnect any cables or perform installation, maintenance, or reconfiguration of this product during an electrical storm.

•Connect all power cords to a properly wired and grounded electrical outlet.

•Connect to properly wired outlets any equipment that will be attached to this product.

•When possible, use one hand only to connect or disconnect signal cables.

•Never turn on any equipment when there is evidence of fire, water, or structural damage.

•Disconnect the attached power cords, telecommunications systems, networks, and modems before you open the device covers, unless instructed otherwise in the installation and configuration procedures.

•Connect and disconnect cables as described in the following table when installing, moving, or opening covers on this product or attached devices.

viii Intel® Blade Server Fibre Channel Expansion Card SBEFCM4, 4 Gbps: Installation and User’s Guide