Intel® Solid-State Drive DC S3500
Product Specification December 2013
22 328860-003US
Table 18. SMART Attributes
ID Attribute Status Flags Threshold
SP
EC
ER
PE
OC
PW
25 <= result <= 5000000, lower indicates specific error
code.
Bytes 2-3: Minutes since last test, saturates at max
value.
Bytes 4-5: Lifetime number of tests, not incremented on
power cycle, saturates at max value.
Normalized value: set to 1 on test failure or 11 if the
capacitor has been tested in an excessive temperature
condition, otherw is e 100.
B7h
SATA Downshift Count
Raw value: reports number of times SATA interface
selected lower signaling rate due to error.
Normalized value: always 100.
1 1 0 0 1 0 0 (none)
B8h
End-to-End Error Detection Count
Raw value: reports number of End-to-End detected and
corrected errors by hardware.
Normalized value: always 100.
1 1 0 0 1 0 0 (none)
BBh
Uncorrectable Error Count
Raw value: shows the number of errors that could not
be recovered using Error
Correction Code (ECC).
Normalized value: always 100.
1 1 0 0 1 0 0 (none)
BEh
Temperature - Airflow Temperature (Case)
Raw value: reports SSD case temperature statistics.
Bytes 0-1: Current case temperature, Celsius
Byte 2: Recent min case temperature, Celsius
Byte 3: Recent max case temperature, Celsius
Bytes 4-5: Over temperature counter. Number of times
sampled temperature exceeds drive max operating tem-
perature specification.
Normalized value: 100 – case temperature in C degrees.
1 0 0 0 1 0 0 (none)
C0h
Power-Off Retract Count (Unsafe Shutdown Count)
Raw value: reports the cumulative number of unsafe
(unclean) shutdown events over the life of the device. An
unsafe shutdown occurs whenever the device is powered
off without STANDBYIMMEDIATE being the last command.
Normalized value: always 100.
1 1 0 0 1 0 0 (none)
C2h
Temperature - Device Internal Temperature
Raw value: Reports internal temperature of the SSD in
degrees Celsius. Temperature reading is the value direct
from the printed circuit board (PCB) sensor without offset.
Normalized value: 150 –
device temperature in C degrees,
100 if device temperature less than 50.
1 0 0 0 1 0 0 (none)
C5h
Pending Sector Count
Raw value: number of current unrecoverable read errors
that will be re-allocated on next write.
Normalized value: always 100.
0 1 0 0 1 0 0 (none)
C7h
CRC Error Count
Raw value: shows total number of encountered SATA
interface cyclic redundancy check (CRC) errors.
Normalized value: always 100.
1 1 0 0 1 0 0 (none)
E1h
Host Writes
Raw value: reports total number of sectors written by the
host system. The raw value is increased by 1 for every
65,536 sectors (32MB) written by the host.
Normalized value: always 100.
1 1 0 0 1 0 0 (none)