Interquartz IQ333 manual Location, Wall Mounting, Headset, Line Connection

3.Set the Ringer Volume (OFF / Low / Hi)

4.See following sections to complete the installation

LOCATION

The telephone should be placed on a desk, table or shelf where it is not likely to be pushed off. If the unit is to be wall mounted, it

should be attached securely on the WALL MOUNTING BRACKET. Avoid excessive heat, damp, dust, direct sunlight, vibration, and

other appliances or devices that may transmit or emit electrical or electromagnetic radio frequency noise or signals (e.g. computers,

welders, and pagers).

WALL MOUNTING

1.To enable the HANDSET to be supported in the cradle, follow the procedure shown in Figure 2 to reverse the HANDSET

RETAINER in the cradle.

2.Fit the WALL MOUNT BRACKET (optional, not supplied) to the wall and attach the WALL MOUNT BRACKET to the underside

of telephone (see Figures 2 and 3)

3.NOTE: The WALL MOUNT BRACKET illustrated in Figure 2 is available from your authorised Interquartz dealer. The

MODULAR WALL JACK illustrated is not applicable to New Zealand.

HEADSET

Connect the headset to the headset socket of the telephone base marked HEADSET, and set the HEADSET POLARITY SWITCH

and HEADSET MIC ADJUST CONTROL described later in this section.

LINE CONNECTION

This telephone is normally supplied with an RJ45-Plug terminated line cord as the wall plug, with the center pair being reserved for speech and signaling. Other types of plugs and cords are available on request.

16