Invacare 1094953, 1094952, 1036794, 1036793 operating instructions Safety Summary, Purpose

Space Saver / ConventionalArm SocketAssemblies

Assembly, Installation and Operating Instructions

Kit Numbers 1036793, 1036794, 1094952, 1094953

SAVE THESE INSTRUCTIONS

NOTE: Check all parts for shipping damage before us- ing. In case of damage, DO NOT use the equipment. Contact the Dealer/Carrier for further instructions.

SAFETY SUMMARY

The following recommendations are made for the safe use of the Space Saver/ Conventional Arm Socket Assemblies:

GENERAL WARNING

DO NOT install or use this equipment with- out first reading and understanding these instructions. If you are unable to under- stand the Warnings, Cautions or Instruc- tions, contact a healthcare professional, dealer or technical personnel before at- tempting to install this equipment - other- wise, injury or damage may occur.

INSTALLATION WARNING

After ANY adjustments, repair or service and BEFORE use, make sure that all at- taching hardware is tightened securely.

PURPOSE

To replace existing half-arms or install new FIXED or AD- JUSTABLE arms on Invacare MVP and STYLE wheel- chairs built after 10-10-92.

The Invacare MVP or STYLE can be fitted with Space Saver or Conventional mounting brackets with either fixed oradjustable arms. These arms can be used on all chairs 14 through 18 inches.

FRONT ARMREST SOCKET REPLACEMENT/H-BLOCK INSTALLATION (FIGURE 1)

1.Remove the locknut and screw securing the H-block to the right and left front frames (FIGURE 1).

2.Remove the H-blocks.

NOTE: It may be necessary to reposition the wheel lock assemblybefore/afterinstallingthenewfrontarmrestsock- ets/H-Blocks.

3.Position the NEW armrest socket/H-Block onto the right and left front frames by performing one (1) of the following:

NOTE: Armrest sockets/H-Block MUST be positioned in the 1st or 2nd mounting hole on the right and left front frames depending on the type of wheelchair.

A.MVP/STYLE 14 through 16 inches deep - Align the mounting hole in the H-block with the first mounting hole on front of chair.

B.ALL type wheelchairs 17 and 18-inch deep - Align the mounting hole on the H-block with the second mounting hole on front of chair.

	Armrest Socket/
	H-Blocks
Mounting	Mounting
Holes	Holes
	Front Frames

FIGURE 1 - FRONT ARMREST SOCKET REPLACEMANT/H-BLOCK INSTALLATION

1