Bolt-In-Place/Spring Button Front Rigging Kit
AssemblyandInstallationInstructions
Kits No. 1110266 and 1121271
SAVE THESE INSTRUCTIONS
NOTE: Check ALL parts for shipping damage. In case of shipping damage, DO NOT use. Contact Carrier/Dealer for further instruction.
SAFETY SUMMARY
To ensure the safe installation of the
WARNING
DO NOT install or use this equipment without first reading and understanding these instructions and the Owner’s Manual supplied with the wheelchair. If you are unable to understand the Warnings, Cautions or Instructions, contact a healthcare professional, dealer or technical personnel before attempting to install this equipment - otherwise, injury or damage may occur.
INSTALLATION WARNING
After ANY adjustments, repair or service and before use, make sure all attaching hardware is tightened securely - otherwise injury or damage may occur.
DESCRIPTION | QUANTITY |
|
|
Riv Nut | 2 |
Button Head Screw | 2 |
1 | |
|
|
Spring Buton Front Rigging kit 1112127 contains the following items:
DESCRIPTION
Spring buttons
QUANTITY
4
INSTALLING THE BOLT-IN-PLACE FOOTPLATE KIT (FIGURE 1)
NOTE: This kit mounts the footplate assembly to the front rigging support so that tools are required to remove or adjust the footrest assembly.
1.Remove the front rigging from the wheelchair. Refer to the wheelchair owner’s manual shipped with wheelchair.
2.Pull up on the cam lock lever to unlock the cam.
NOTE: The elevating legrest has two (2) sets of release buttons, one (1) set above the other. Each set will be visible one at a time allowing finer footplate height adjustment.
3.Push IN and hold the release button as shown in DETAIL “A” of FIGURE 1.
4.Rotate the lower footplate assembly 1/4 turn.
Part No. 1114831 | 1 | |
|
| Front Rigging Kit |
