4 INSTALLATION
4 Installation
WARNINGS
Check all parts for shipping damage. In case of damage, DO NOT use. Contact the carrier for further instruction.
The installation area MUST be able to support the 66 pounds per square inch (45 n/cm²) load capacity of the tub. Otherwise, injury or damage may occur.
Access for servicing the tub MUST be provided. Install the tub in a location that will permit access to the service panels, plumbing and electrical hookups.
CAUTIONS
DO NOT lift the tub by the plumbing.
DO NOT modify the tub in any way. Modifications to the system or any component may cause the system to malfunction and will void the warranty.
ICCI assumes no responsibility for code infractions or damage to components due to improper installation. Use extreme care during installation.
After installation and before use ensure all parts are properly and securely installed.
Ensure the bathroom floor is dry and free of obstructions before transporting or assembling the unit.
4.1Preparing the Work Area
Access for servicing the tub MUST be provided.
Follow the recommended floor plan when installing the tub. Refer to Minimum Floor Space and Clearance Requirements on page 12.
1.Determine location for the tub installation.
2.Carefully remove the tub from the carton and inspect for shipping damage. If damage is found, contact the carrier.
3.Remove the tub from the shipping pallet by removing the screws from the leg mounting pads.
4.Remove the four screws securing the service access panel on the back of the tub.
Invacare® TheraPure™ Side Entry Whirlpool Tubs | 16 | Part No. 1167457 |
