Assembling The I.V. Stand Figure, MODELS 6681-5 AND, Model

ASSEMBLING THE I.V. STAND (FIGURE 2)

1.Perform one (1) of the following:

1.Place black plastic insert into the hole pro- vided on top of the base.

2.InsertthelowerI.V.tubethroughtheblackplas- tic insert and the base.

3.Secure the lower I.V. tube to the base with the large steel washer, small steel washer, lock washer and bolt. Securely tighten.

1.Align the upper base half and the lower base half as shown in FIGURE 2.

NOTE: The lower base half has a recess.

2.Insert the bolt UP through wrench, small steel washer, mounting holes in lower base half and upper base half and large steel washer.

3.Secure the lower I.V. tube to the base with the bolt. Tighten securely.

2.Place I.V. hanger onto the threaded end of the upper I.V. tube. Turn clockwise to tighten.

NOTE: Ensure the I.V. hanger is screwed tightly onto the upper I.V. tube.

3. Insert upper I.V. tube into the lower I.V. tube.

Adjusting Knob

Lower I.V. Tube

Black Plastic

Insert

Small Steel

Washer

Lock Washer

I.V. Hanger

Threaded

End

Upper

I.V. Tube

Base

Large steel washer

Bolt

4.	Insert adjusting knob into the mounting hole on the
	lower I.V. tube.
5.	RaisetheupperI.V.tubetothedesiredI.V.standheight.
6.	Tighten adjusting knob, by turning clockwise, at de-
	sired I.V. stand height.

Adjusting Knob

I.V. Hanger

Threaded

End

Invacare Corporation	www.invacare.com

USA	Canada
One InvacareWay	5970 Chedworth Way	Invacare and "Yes,you can" are trademarks of Invacare
Elyria, Ohio USA	Mississauga, Ontario	Corporation.
44036-2125	L5R 3T9, Canada	© 2000 Invacare Corporation
800-333-6900	905-890-8838	Form No. 96-140 Part No. 1063112 RevA (1) 8/2000