DRIVING | PROCEDURE 1 |
ADJUSTING DRIVE ARM HEIGHT (FIGURE 2)
1.Remove the button screw located on the drive arm.
2.Lift up on the drive arm to expose the plunger tube.
3.Align one (1) of the three (3) mounting holes in the plunger tube with the button screw mounting hole on the drive arm.
4.Install the button screw into the drive arm and plunger tube mounting hole to secure the drive arm to the plunger tube. Tighten securely.
ADJUSTING DRIVE ARM RELEASE LEVER AND/OR BRACKET LEVER (FIGURE 2)
NOTE: The drive arm release lever and/or bracket lever can be rotated to keep it from protruding from the drive arm.
NOTE: CLDs built AFTER 09/05/00 DO NOT have a drive arm release lever.
1. Depress and hold the button on the release lever.
2.Rotate the release lever to the desired position.
3.Release the button.
ADJUSTING DRIVE ARM TENSION (FIGURE 2)
NOTE: Adjusting the drive arm tension will increase/re- duce the amount of effort required to move the drive arm.
1.Turn the bracket lever COUNTERCLOCKWISE to loosen.
2.Slide the bracket up or down to adjust the amount of effort required to move the drive arm.
UP - Increases the amount of effort required. DOWN - Decreases the amount of effort required.
NOTE: It may be easier to pull up or push down on the wheel lock adjustment lever to move the bracket up or down.
3.Turn the bracket lever CLOCKWISE to tighten. Tighten securely.
D R I V I N G
CLDs Built BEFORE 09/05/00
Button | Drive Arm | |
| ||
Screw |
| |
| Mounting Hole | |
| Plunger Tube | |
| Drive Arm | |
| Release | |
| Lever | |
Button | Wheel | |
Lock | ||
| ||
| Adjustment | |
| Rod | |
Bracket | Bracket | |
Lever |
|
CLDs Built AFTER 09/05/00
Button Screw |
| |
| Drive Arm | |
Bracket | Mounting Hole | |
Lever | ||
| ||
| Plunger Tube |
Wheel
Lock
Adjustment
Rod
Button
Bracket
FIGURE 2 - ADJUSTING DRIVE ARM HEIGHT
5
