SPECIFIC WARNINGS (CONTINUED)
Most tub floors are higher than the bathroom floor. Before using, ensure that the two (2) legs of the transfer bench inside the tub are adjusted to the same height and the two (2) legs outside the tub are adjusted to the same height, so as to achieve an even height adjustment. DO NOT use if wobbly or unstable.
After ANY adjustments, repair or service and BEFORE use, make sure all attaching hardware is securely tightened - otherwise injury or damage may result.
INSTALLING THE SEAT ARM
NOTE: Before performing this procedure, carefully read and understand the Safety Summary of this instruction sheet.
NOTE: The end rail is already installed on the transfer bench and must be removed when installing the seat arm.
1.Remove the two (2) LONGER mounting screws and locknuts that secure the leg frame to the end rail.
NOTE: The LONGER mounting screws are the ones that have more exposed threads beyond the lock nut.
2.Position the seat arm on the side of the transfer bench where backrest is attached.
3.Install one (1) LONGER mounting screw through seat arm and leg frame.
4.Secure seat arm to the leg frame with the locknut.
NOTE: Locknut located on inside or end rail side of product.
5.Repeat STEPS 3 AND 4 for opposite side.
6.Securely tighten all hardware until a resistance is felt and all slack is removed.
7.Adjust leg extensions. Refer to Adjusting Leg Extensions on page 3.
Locknut LONGER
Mounting
Screw
Leg Frame
End Rail | Seat Arm |
|
FIGURE 1 - INSTALLING THE
SEAT ARM
Transfer Bench | 2 | Part No 1075940 |
