Invacare JLS5 Installing the Jasmine Scale

Part No 1152408 3Jasmine™ Scale JLS5
Installing the Jasmine Scale
NOTE:Forthisprocedure,refertoFIGURE 2.
 WARNING
Patient and sling MUST be removed from the lift during ALL installation procedures.
1. PositiontheloadcellassemblyoftheJasmineScaleintotheboommountingbracket(DetailʺAʺof
FIGURE 2).
2. SecuretheJasmineScaletotheboommountingbracketwithabolt,washers,bushings,nylon
washers,locknutandthetoprubbercap.Securelytighten.Installthesmallrubbercap.
NOTE:RefertoDetailʺAʺofFIGURE 2forwasherandsmallrubbercaporientation.
NOTE:Ensuretheshaftoftheboltpassesthroughbothsidesoftheboommountingbracket.
3. Insertswivelbarpinwithano‐ringandawasherthroughtheswivelbar(DetailʺBʺofFIGURE 2).
4. Alignthemountingholesintheswivelbarpinwiththemountingholesintheloadcellassembly
(DetailʺBʺofFIGURE 2).
5. Secureswivelbarpintotheloadcellassemblywithascrewandlocknut.Tightensecurely(Detail
ʺBʺofFIGURE 2).
 WARNING
After ANY adjustments, repair or service and BEFORE use, make sure all attaching hardware is
tightened securely - otherwise injury or damage may occur.
6. Weighthepatient.RefertoOperatingtheScaleandWeighin gthePatientintheJasminePatient Lift
Owner’sManual,InvacareP/N1150704.
FIGURE 2 Installing the Jasmine Scale
Locknut
Swivel Bar
Washer
Swivel Bar Pin
Screw
Jasmine
Scale
Jasmine
Scale
Load Cell
Assembly
Bolt
DETAIL “B”
DETAIL “A”
Locknut
Nylon
Washers
Washer
O-Ring
Top Rubber
Cap
Bushing
Small
Rubber
Cap
Boom
Mounting
Bracket
Bushing
Washer