Invacare TRACER EX manual Adjusting Front Anti-tippers, Triangular Assembly Wheel Inch

OPTIONS PROCEDURE 8

Adjusting Front Anti-tippers

1.Measure from the floor to the bottom of the wheels of the triangular assembly.

2.Perform one (1) of the following:

TRIANGULAR ASSEMBLY 3/4-INCH FROM FLOOR - Repeat STEP 1 for the opposite triangular assembly.

TRIANGULAR ASSEMBLY NOT 3/4-INCH FROM FLOOR - Proceed to STEP 3.

3.Remove the machine screw, washers and locknut securing the triangular assembly to the bottom of the anti-tipper arm.

4.Position the triangular assembly mounting hole to align with one (1) of the adjustment holes in the anti- tipper arm.

5.Measure from the floor to the bottom of the wheels of the triangular assembly.

6.Repeat STEPS 4-5 until the bottom of the wheels of the triangular assembly measure approximately 3/4-inch from the floor.

7.Secure the triangular assembly to the bottom of the anti-tipper arm with the machine screw, washers and locknut.

WARNING

DO NOT overtighten the locknut securing the tri- angular assembly to the bottom of the anti-tip- per arm. Otherwise, anti-tipper arm will not swing freely and the wheelchair may tip over, resulting in injury or damage.

8.Tighten the locknut until the triangular assembly does not rattle, but swings freely at the end of the anti- tipper arm.

9.Repeat STEPS 1-2 for the opposite triangular as- sembly.

O P T I O N S

INSTALLING			ADJUSTING
Wheelchair Frame			Anti-Tipper Arm
	Lug Bolts		Washer
			Machine
	Front Caster	Adjustment	Screw
	Attaches Here
Bracket Clamps		Holes
	(not shown for
	clarity)
Locknuts	Anti-Tipper	Locknut	Mounting
			Holes
	Arm
Triangular Assembly
		Triangular	Wheel
NOTE: Right side Front Anti-Tipper pictured.		Assembly	é
			3/4-inch
			ê

FLOOR

FIGURE 5 - INSTALLING/ADJUSTING THE FRONT ANTI-TIPPERS

27