Solid Seat Installation / Replacement for
Model 1000,Tracer LX,Tracer IV, andTracer EXWheelchairs
Assembly, Installation and Operating Instructions
Model Nos. 1610, 1610P, 1610N, 1610PN
SAVE THESE INSTRUCTIONS
ADULT/HEMI REMOVABLE ARM
WHEELCHAIR
NOTE: Check all parts for shipping damage before using. In case of damage, DO NOT use the equipment. Contact the Dealer/Carrier for further instructions.
SAFETY SUMMARY
The following recommendations are made for safe installation of the Solid Seat.
GENERALWARNINGS
DO NOT install or use this equipment without first reading and understanding these instructions. If you are unable to understand the Warnings, Cau- tions or Instructions, contact a healthcare pro- fessional, dealer or technical personnel before attempting to install this equipment - otherwise, injury or damage may occur.
INSTALLATION WARNING
After ANY adjustments, repair or service and BE- FORE use, make sure that all attaching hard- ware is tightened securely.
Seat Guides
(REAR) and
Tension Springs
Crossbrace
Pivot Nut
Seat Upholstery
Reinsert Two (2)
Screws Here
Seat Guides
(Front of Chair)
Crossbrace
Pivot Bolt
INSTALLING THE SOLID SEAT - MODEL 1000 AND TRACER LX WHEELCHAIRS ONLY (FIGURES
NOTE: If not stated specifically, the procedure refers to both Adult/Hemi, Removable, and Permanet Arm Wheelchairs.
1. Remove wheelchair arms.
NOTE: Some wheelchairs may have permanent arms.2.Fold chair.
3.Remove seat upholstery (All Chairs) and reinsert two
(2) screws behind the front two (2) spacers on the seat rails (Adult/Hemi Removable Arm) (FIGURE 1).
4.Remove the crossbrace pivot bolt and locknut from crossbrace (FIGURE 1).
5.Lift one (1) seat guide (front of chair) up and out of the side frame (Removable arm only) (FIGURE 1).
6.Remove the rear seat guide and tension spring from the seat rail (FIGURE 1).
NOTE: For Permanent Arm Wheelchairs remove seat guides from front and rear of chair (FIGURE 1).
7. Repeat steps 5 and 6 for opposite side frame.
PERMANENT ARM
Seat Guides and
Tension Springs
(REAR)
Crossbrace
Pivot Nut
Seat Guides
(Front)
Crossbrace
Pivot Bolt
FIGURE 1 - DISASSEMBLY OF THE WHEELCHAIR TO
INSTALL SOLID SEAT
1