Installation

Step 4. Turn on power to the ADC Display

Note: The Power On default is to link to ADC Port 1 . If the computer attached to ADC 2 is inactive, the display will be blank so it may appear as if the unit is not functioning. This is not the case. Simply use the Port Selection push button (described below), to switch to the active computer on the other ADC 2 port.

Step 5. Turn on power to the connected computers that is selected.

Note: GCS602 only allows computer to boot on the slected port.

11

Page 13
Image 13
IOGear GCS602 user manual Installation