300
how to assemble and use
Please note: make sure the permanent
1.Keep both sides of the unit more than 4 inches away from a wall.
2.Do not blow air from a fan or air conditioner directly into the air purifier.
3.Do not place the unit where the air inlet or outlet grill could come in contact with a curtain.
4.Placing the unit close to the source of air pollution can improve indoor air quality effectively.
1.2.
3.4.
6
operating your Therapure® 300D
Plug the unit into an electrical outlet. The unit will be ready to run. Read the following directions to select desired settings.
Control Panel
1.Press the ON/OFF button to turn on your air purifier and press it again to turn it off.
2.When the air purifier is turned on, the fan will run at low speed (this is the default speed). Press the SPEED button to cycle through the fan speeds shown below:
Low 
Medium 
High 
Quiet
3.While the fan is running, press the TIMER button to the select the desired run time (in hours) as shown below:
1h 
2h 
3h 
4h 
5h 
6h 
7h
time off 
12h 
11h 
10h 
9h 
8h
4.Press the ION button to turn on the ionizer while the fan is running and press it again to turn off the ionizer.
5.Press the UV/VOC button to turn on the germicidal light and filter. Press it again to turn off.
7
