IP_CA500_Mnl_Rev_092707.qxp:Layout 1 6/3/08 2:56 PM Page 12
COLLECTION BLADES
HELPFUL TIPS: Remember to clean your Ionic Pro® ionic air purifier every month and any time the red CLEAN/FAULT light comes on or whenever you hear your unit begin to make excessive noise.
To Clean the Collection Blades
Turn off and unplug your Ionic Pro®air purifier. Let the unit rest a minute. Next, lift off the removable cap and slide the collection blades out of the top of your Ionic Pro® ionic air purifier.
Do not touch the metal blades until after discharging residual electricity by touching blades to an electrical ground such as water pipe or metal faucet. Wipe away the trapped particles collected on the three blades with a slightly damp sponge or cloth. If you use a slightly damp cloth to clean the blades, it is possible the collection blades will be completely dry within two to three hours. Always allow the collection blades to dry thoroughly before resuming use.
To Clean the Ionizing Wires
The internal ionizing wires need to be cleaned after every two weeks of use. There is a Wire Cleaning Mechanism used to clean the internal ionizing wires which you slide up and down to scrape off particle residue. (see Diagram B of the Operating Panel to locate the Wire Cleaning Mechanism). Lift and lower the Wire Cleaning Mechanism three or four times to thoroughly clean the ionizing wires (see Diagram H).
REMEMBER TO ALWAYS RETURN THE WIRE CLEANING MECHANISM TO ITS ORIGINAL POSITION BEFORE ATTEMPTING TO RESUME USE OR THE UNIT WILL NOT FUNCTION.
IMPORTANT: To avoid damaging your Ionic Pro® ionic air purifier, make sure the collection blades are completely dry and free of all moisture and that your Ionic Pro® ionic air purifier is turned off and unplugged before attempting to
If you have used soap and water to clean the collection blades, wait at least 24 hours to ensure that they are thoroughly dry before
H. CLEANING WIRES
10 | 11 |
CLEAN ING & MAIN TENA NCE | CLEAN ING & MAINTENANCE |