Ionic Pro CA500 manual Tro Uble-Shoo Ting, Deep Cleaning, Cleaning External Surfaces

IP_CA500_Mnl_Rev_092707.qxp:Layout 1 6/3/08 2:56 PM Page 14

TRO UBLE-S HOO TING

Deep Cleaning

Noisy functioning (audible loud buzzing sound) is a sign that your Ionic Pro® ionic air purifier is overdue for a complete clean-up of the collection blades and the internal ionizing wires. The internal ionizing wires must be kept clean to ensure silent and normal operation.

For deep cleaning, follow both the “TO CLEAN THE COLLECTION BLADES”

&“TO CLEAN IONIZING WIRES” sections.

IMPORTANT: MAKE SURE THE THOROUGHLY CLEANED AND DRIED COLLECTION BLADES ARE PROPERLY INSERTED, THE REMOVABLE CAP IS BACK IN ITS ORIGINAL POSITION, AND THE WIRE CLEANING MECHANISM IS BACK IN ITS ORIGINAL POSITION BEFORE RESUMING USE—OR THE UNIT WILL NOT FUNCTION.

Cleaning External Surfaces

Over time, some particles and dust may accumulate on the external surfaces of your Ionic Pro® ionic air purifier. If this happens, turn off and unplug the unit. Mix one ounce of laundry bleach with five ounces of water and apply sparingly with a sponge to wipe the outer case surfaces. Do not allow water to slip into the internal parts of the Ionic Pro® ionic air purifier as this could damage its functioning and may result in injury to you. Allow the unit to dry for at least 24 hours before resuming use.

TROUBLE	REASON	TROUBLE-SHOOTING
Indication/Setting light	Machine is unplugged.	Check if plug is loose.
not on	ON/OFF button has not	Press the ON/OFF
	been pressed.	button.
Red CLEAN light is on	Too much dust has	Turn off, unplug and clean
	accumulated.	using instructions from the
		“Deep Cleaning” section.
	Collection blades	Remove and re-insert
	are jarred or removed	collection blades
	suddenly.	and press "on"
		button to reset.
	Red light may go on	Press “on” button to reset.
	if the unit just needs
	to be “reset”.
Excessive noise	Too much dust has	Clean and dry blades
generated*	accumulated or internal	and ionizing wires
	parts are wet.	thoroughly*. Keep the
		machine dry.
Collection blades do not	Improper blade orientation	Reverse blade orientation
go back in
Indication light does not	Collection blades are not	Check to see that the
go on	completely inserted.	blades are completely
		seated in housing.
	Wire Cleaning Mechanism is	Check to see that Wire
		Cleaning Mechanism
	not completely inserted
		is completely seated in
		housing.

*See “Cleaning & Maintenance” section

12 13

CLEAN ING & MAIN TENA NCE TROUB LE-SHOOT ING