Scooba Maintenance, Clean Scooba’s Filter | iRobot Cleaning System

Scooba Maintenance

To keep Scooba running at peak performance, perform the following maintenance tasks after every cleaning cycle:

Rinse Scooba’s Dirty Tank

1Partially fill the Dirty tank with water.

2Empty and rinse the Dirty tank.

Clean Scooba’s Filter

1 Remove filter.

2 Rinse under warm water.

3 Replace filter.

CAUTION: Scooba contains electronic components that can be damaged by spills of water or other liquids. Clean the bottom and top of Scooba with a damp cloth only. Do not pour or spray water onto Scooba, other than into the Clean or Dirty tanks.

www.irobot.com 17

Image 17

iRobot Cleaning System owner manual Scooba Maintenance, Rinse Scooba’s Dirty Tank, Clean Scooba’s Filter

Contents

IRobot Scooba Page Page For Best Performance Important Tips Table of Contents Robot Base Scooba’s Tank Scooba’s Anatomy See page 18 for detailed instructions Scooba’s Lights Scooba’s Cleaning Pattern Battery Life Hour Refresh Charge Battery PerformanceBattery Storage Removing Battery from Scooba Battery Installation and RemovalInstalling Battery in Scooba Charging Scooba Scooba’s Tank Clean Tank Dirty Tank Internal Drying Mode Scooba’s Cleaning System Approved Cleaning Solutions Scooba Cleaning Solution Scooba’s Virtual Wall Rinse Scooba’s Dirty Tank Scooba MaintenanceClean Scooba’s Filter Rinse Scooba’s Vacuum Port After Every Use Clean Scooba’s Brush After Every Use Avoiding Common Mistakes Make Sure Battery is Installed CorrectlyClick Cleaning Head into Place Re-install the Vacuum Port Remember to Re-install Filter Troubleshooting ’m Stuck Light Service Codes Check Tank Troubleshooting General Troubleshooting IRobot Customer Care Hours IRobot Customer Care General Safety Instructions Important Safety Instructions Scooba USE Restrictions Page Page Get iRobot accessories at Or visit store.irobot.com