Ives installation instructions 112HD & 224HD Series Concealed Continuous Hinges, Cut hinge

B. In this case remove the set screw bearing from the cut off section by loosening set screw and sliding back channel.

Installation Instructions

829168-00

112HD & 224HD Series Concealed Continuous Hinges

!CAUTION

Please follow the installation instructions carefully. Not doing so may result in improper installation and void

the manufacturer’s guarantee. These hinges have a permanent, factory applied lubricant. Removal or

alteration of this lubricant, anodizing or painting of the product in the field will void the guarantee.

INSTALLATION NOTES

Reinforcing and Rivet nuts: No reinforcing is necessary except on extremely high frequency, extremely heavy or extra-wide doors. Rivet nuts are required in the frame and door when door weight exceeds 450 pounds (up to 600 pounds).

Pairs of Doors with Mullions: If the mullion is between the doors, treat as a single door installation. If the mullion is behind the doors, treat as a double door installation.

HINGE CUTTING (IF NECESSARY)

Note: All standard length hinges are supplied slightly shorter than nominal door height to avoid threshold or carpet- ing clearance problems. All uncut hinges are templated and non-handed. Use the same model for both right and left hand openings. If hinge is longer than door and needs cut, follow instructions below. Once the hinge is cut it becomes handed because the cut end must go on bottom.

1	Determine hinge height.	3 Special note, when cutting off
	If hinge is taller than door, hinge must be cut to match	more than 13.50”.	Set screw
	door height. Hinge must not be taller than door height.
			bearing
	Mark hinge with line where cut is needed.	A. If more than 13.5” is cut from
		bottom of hinge, a set screw
2	Cut hinge.	bearings will be cut off. This
		set screw bearing is required
A. Fold hinge so that channel is up.		for proper operation.

B. Starting on channel, cut through entire hinge along line.

C. Debur all cut edges with file.

C. Loosen set screw(s) on hinge, slide back channel, and replace a non set screw bearing with a set screw bearing.

D. Slide channel back into place
and tighten all set screws.	Channel

! CAUTION

83”, 85”, and 95” hinges require 2 set screw bearings.

120” hinges require 3 set screw bearings.

829168-00(1) © 2006 Ingersoll-Rand Company Limited