Ives 7245F installation instructions Right hand installation shown left hand opposite

Installation Instructions

7244F and 7245F

1-1/2” Intermediate Pivot

Door leaf

Frame leaf

Right hand

installation shown; left hand opposite

Right hand	Pivot pin height	Left hand
installation	adjuster	installation
	Pivot
	cap
	5/32” Allen
	wrench

1.Prepare and mortise hinge stile of door and hinge side jamb to receive pivot set. Determine pivot location using dimensions on reverse side. The pivots are handed and must match hand of door. To determine hand of door and proper pivot position, see diagrams above. Install top and bottom pivot sets before installing intermediate pivot.

2.Locate, drill, and tap 1/4-20 mounting holes for metal door or metal frame. Locate and drill pilot holes for #14 wood screws for wood door or wood frame. Then hang door.

3.Open door about 90°. Install pivot leafs with 1/4-20 x 3/4” FHMS or #14 FHWS screws provided.

4.The door weight should be balanced between bottom and intermediate pivots. Refer to diagram above. To adjust intermediate pivot:

A.Use 5/32” Allen wrench to remove pivot cap from frame leaf.

B.Insert Allen wrench into pivot pin height adjuster.

C.Turn clockwise until pivot pin makes contact with steel ball inside door leaf.

D.Adjust carefully to balance the weight of the door.

5.Re-install pivot cap.

!CAUTION

Improper pivot set installation can lead to personal injury or property damage. Follow all instructions carefully. For questions contact Technical Support at 1-888-371-7331.

26366 Rev. 3 © 2006 Ingersoll-Rand Company Limited