SECTION 5: PARTS SECTION
AJ-86 & AJ-100 CONTROL BOX ASSEMBLY (CONTINUED)
ITEM | QTY | DESCRIPTION | Mfg. No. |
1 | 1 | Electrical Box Weldment | |
2 | 1 | Decal, | |
3 | 1 | Terminal Block | |
4 | 6 | Lockwasher, #10 | |
5 | 2 | Screw, | |
6a | 1 | Light, Amber (Wash Heater Overload) (Not used on steam or gas models) | |
6b | 1 | Light, Amber (Rinse Heater Overload) (Not used on steam or gas models) | |
7 | 1 | Wire Lug, 2 AWG to 14 AWG | |
8 | 1 | Light, Red (Power) | |
9 | 1 | Din Rail | |
10 | 3 | Screw, | |
11 | 1 | Washer, Flat, 1/4” | |
12 | 1 | Decal, Ground | |
13 | 1 | Terminal Board | |
14a | 1 | Drive Motor Contactor | |
14b | 1 | Wash Pump Motor Contactor | |
14c | 1 | Recirculating Rinse Pump Motor Contactor | |
14d | 1 | Prewash Pump Motor Contactor | |
15 | 1 | Circuit Breaker (208 & 230 volt models only) | |
16a | 1 | Recirculating Rinse Pump Motor Overload (See motor overloads chart) | N/A |
16b | 1 | Wash Pump Motor Overload (See motor overloads chart) | N/A |
17 | 1 | Switch, ON/FILL & OFF/DRAIN | |
18 | 1 | Drive Motor Overload (See motor overloads chart) | N/A |
19 | 1 | Terminal Board | |
20 | 2 | Heater Contactor (Not available on seam models) | |
21 | 2 | Screw, | |
22 | 1 | Transformer | |
23 | 4 | Locknut, | |
24 | 1 | Fuse Holder (460 volt models only) | |
25 | 1 | Fuse (460 volt models only) | |
26 | 12 | Screw, | |
27 | 7 | Control Relay, 2 Pole (5 for Gas models, 1 not shown) | |
28 | 3 | Relay, 3 Pole (Gas models only) | |
29a | 1 | Rinse Thermometer, 96” | |
|
| Decal, Rinse 180°F | |
29b | 1 | Power Rinse Thermometer, 96” | |
29b | 1 | Power Rinse Thermometer, 120” | |
|
| Decal, Power Rinse 160°F | |
30a | 1 | Wash Thermometer, 120” | |
30a | 1 | Wash Thermometer, 96” | |
|
| Decal, Wash 150°F | |
30b | 1 | Prewash Thermometer, 120” | |
31 | 1 | Power Rinse Thermometer | |
|
| Decal, Power Rinse 160°F | |
32 | 1 | Decal, Gauge | |
Items not shown: |
| ||
|
| Grommet, 1/2” OD x 3/8” ID | |
|
| Bushing, Heyco SB100 | |
|
| Plug, Heyco 2700 | |
|
| Control Box Cover | |
|
| Control Box Cover Hinge Weldment | |
|
| Control Hinge Rod | |
|
| MANUAL/DELIME Switch (Located on rear of contol box) | |
|
| MANUAL/DELIME Decal | |
|
| Copper Conductors Only Decal | |
|
| Control Box Leg | |
|
|
|
|
|
|
|
|
|
|
|
|
Issued:
57