SECTION 2: INSTALLATION/OPERATION INSTRUCTIONS
UNIVERSAL TIMER PROGRAMMING INSTRUCTIONS
INSTRUCTIONS FOR CHEMICAL FEEDER PUMPS (FOR INSTALLATION TECHNICIAN ONLY)
To access the programming mode, the machine must be ON, and idle (between cycles).
On the timer board, press both the MOVE and ENTER buttons on the timer board simultaneously.
The PROGRAM light will illuminate and the A light will blink.
Once in the programming mode, the MOVE button is used to scroll between the programming categories and the ENTER but- ton is used to select the category.
Press the MOVE button to move the blinking light between FILL, RINSE AID, DETERGENT or SANITIZER.
Press the ENTER button for the chosen category.
The PROGRAM light will illuminate along with the lights corresponding to the time values for the chosen category. The ACCEPT light will blink.
To change the value of a parameter, use the MOVE button to move the blinking light to the time option (time is in seconds). In the time categories, each second in use will light up. To deselect the option, press ENTER and the light will go off, press ENTER again and it will illuminate. Once you have set your time category, press the MOVE button until the ACCEPT light is blinking and press ENTER. This will save the changed parameters.
Once you press the ENTER button when the ACCEPT light is blinking, you will exit the programming mode. To change any other values, you will have to return to the programming mode. To revert back to a previous setting, you must return to that option and change the parameter back to the previous setting.
Once in the programming mode, if there have been no keypad inputs for approximately 2 minutes, the system will automati- cally exit out of the programming mode. Any changes to parameters will be saved when the programming mode is automati- cally exited.
All time adjustments are in seconds. Refer to the chart below for the adjustable outputs.
Please note that options A, B, and D are not adjustable outputs.
Conserver XL Series Technical Manual
Issued:
23
