www.jacksonmsc.com
Removing the wire nuts. | The WRONG way to mount the drive motor. |
11.Once the wire nuts are removed, separate the wires.
12.With the flathead screwdriver and the hammer, loosen the con- duit nut. Once loosened, pull the conduit away from the motor. The motor may now be disposed of.
13.Remove the access cover off of the new motor.
14.Attach the conduit and pull the wires through the hole provid- ed. Tighten the conduit nut.
15.Using the wire nuts, wire the motor back the same way the old one had been. Refer to the schematic on the motor itself or contact Jackson Technical Service if you any questions.
16.Once the wiring is done, carefully push wires back into the motor and put the access cover back on. Tighten down the screws for securing it.
17.The drive motor now needs to be reattached to the gear reduc- er. There are two methods for doing this. The first is to try and and reinsert the drive motor shaft into the gear reducer with it (gear reducer) still attached to the unit. This is difficult but possible. Ensure that the key is in the keyway when you mate the parts. The second method and perhaps the easiest is to remove the gear reducer, mate the two parts and bolt them together and then put them on the unit at one time. This method takes a little more time. If you wish to remove the gear reducer and assemble the two com- ponents continue on to step 27.
18.Once the motor and gear reducer are mated, secure them with the locknuts and bolts. Ensure the bolts are tight.
Note: Because of the way the covers for the drive assembly are designed, it is imperative that you position the motor on the gear reducer so that the conduit fitting is facing towards the front of the dishmachine. If it is facing away from the machine, the covers may not go back on.
The Correct way to mount the drive motor.
19.Reattach the bottom and top drive assembly covers.
20.Proceed to the sections entitled “AFTER MAINTENANCE ACTIONS”.
21.(Continuing from step 7) To remove the gear reducer, first take the 3/4” combination wrench and remove the drive hub bolt.
Removing the drive hub bolt.
4 | Rack Conveyor Drive Motor and Gear Reducer Replacement Instructions | |
Revision A (07/05/2005) | ||
|
