Jackson JFT manual Models, Options, Standard Features, Flight Machine

Flight Machine

Models

Project

Item

Quantity

CSI Section 11400

Approval

Date

FLIGHT

JFT

Options

Blower dryer Additional wash section Additional load module Additional unload module 25’ (8 m) wash down hose - mounted Electrical connection with circuit breakers

Dual point electrical connection Low profile doors

Flanged feet

Multiple conveyor peg choice Drain at load or unload end

Standard Features

•Uses 140 gallons (530 ltrs) of water per hour with sanitizing hot water rinse

•All tanks and hoods constructed from 16 gauge 304 stainless steel with a No. 3 finish and heliarced welded

•Stainless steel frame, legs and feet

•Two tank rackless conveyor shall have a maximum capacity of 17,101 dishes per hour at an NSF rated belt speed of 8.63 feet per minute. At 6.4 feet (2 m) per minute capacity will be 12,726 dishes per hour.

•Belt width of 29” (737 mm) and a maximum clearance of 25” (635 mm) throughout the machine

•Enclosure panels, hood and doors are stainless steel and dou- ble wall insulated to reduce heat dissipation, outside surface temperatures, and noise pollution

•Insulated access doors for removal, cleaning and servicing

•V-shape tank(s) design to increase visibility and accessibility for cleaning as well as insure complete tank draining

•Heated power rinse zone uses fresh rinse water a second time to provide pristine results

•A sequential digital temperature readout of each tank housed in the door of the electrical control panel. The read- outs will constantly display the temperature of the prewash, wash, power rinse and final rinse in 5 second intervals

•A ball valve in the drain line of each tank and interconnected to a common machine drain connection at the load end of the machine

•Each tank will be automatically filled and maintained by a water level float. Water will be automatically added to the machine when required

•Block manifold wash arms are easy to remove, clean, and replace with non-clogging convex wash arm jets

•Large, removable scrap screens

•Self draining stainless steel pumps, impellers, and hous- ings are readily accessible and serviceable

•Conveyor belt drive operates at two speeds and is pro- tected by an overload safety device and an automatic shut-down actuator

•Each door is equipped with a door safety switch to pre- vent it from running when the door(s) are open. If a door is opened during operation the switch will immediately shut down the machine

•Operator activated start-stop switches on both the load and unload ends and the control panel

•Removable insulated panels to enclose the unit down to the base frame on both the front and rear of the machine

•A single, built-in 18” (457 mm) diameter indirect vent connection with a 0.19 HP exhaust fan mounted in a cleanable cross duct on the machine for condensate removal and indirect vent connection

•3” minimum wall clearance

•Service access from front of machine

Highway 25E	Tel: 606-523-9795	www.jacksonmsc.com
P. O. Box 1060	Tel: 1-888-800-5672	07610-002-85-11 (8/07)
Barbourville, KY 40906	Fax: 606-523-9196
	E-mail: info@jacksonmsc.com