www.jacksonmsc.com
17.The tee that the rinse drain nipple is in must be turned 180B so that it is facing the opposite direction. This may require dismantling the plumbing by removing the tee with the wash drain barb in it. Put the plumbing back together, after ensuring that the rinse drain tee has been rotated. Use thread tape to protect the threads while put- ting the plumbing back together. Ensure that the wash drain barb is in the exatc same position it was prior to this step.
18.On the underside of the tub, remove the rinse drain weldment and the rinse drain plug. Switch their locations so that the rinse drain weldment is in the spot that the rinse drain plug was in.
Lifting out the rinse tray assembly
Removing a rinse tray guide bracket
16.On the drain plumbing, the rinse drain tube needs to be removed from the plumbing, as well as the wash drain tube. Both of these tubes are secured with hose clamps. Loosen the hose clamps and pull the tubes off.
Loosening the rinse drain hose from the rinse
drain nipple
Removing the rinse drain weldment
Removing the rinse drain plug
19.Reconnect the rinse drain hose and the wash drain hose to the drain plumbing.
20.On the opposite end from where they were removed, install the front and rear rinse pan assembly locating brackets. Note: the brackets are mounted to the bolts that secure the tub weld- ment to the frame. Install the brackets one at a time and ensure that they are firmly tightened down once installed.
21.Remove the hole cover weldment from the top of the hood. The cover is located on the end of the hood opposite of the rinse injec-
5 | ||
Revision A (03/30/2005) | ||
|
