www.jacksonmsc.com
9.Remove the lower rinse arm support bracket, which is mounted directly opposite of the lower wash arm support bracket.
Removing the lower rinse arm support bracket
12.Remove the nuts from the rinse manifold mounting bracket located on the underside of the hood. These nuts are mounted directly to the rinse injector weldment on the hood top.
Removing the locknuts from the rinse mani-
fold mounting bracket
10.Remove the lower and upper rinse arms by unscrewing them and then gently pulling them out.
Unscrewing and removing the lower rinse arm
11. Behind the rinse manifold, remove the nut on the bracket.
Removing the bracket nut
13.The rinse manifold must be removed. This may prove difficult while the rinse injector is still mounted. With great care, it is possi- ble to gently lift the rinse injector off of the hood to allow the rinse manifold to be removed from the unit. Ensure that the gasket in the underside of the hood stays with the rinse manifold as it must be replaced when
Lifting the rinse injector to make room
14.Remove the entire rinse tray assembly, including the pan and the strainer within in. The assembly should lift right out. (See next page for photograph detailing this step)
15.Remove the front and rear rinse pan locator brackets. Note: the brackets are mounted to the bolts that secure the tub weldment to the frame. Once the locknuts are removed, pull the locator brackets off and immiediately replace the locknuts back onto the bolts. Failure to do so at a minimum may cause excessive leaking of the tub once the unit is placed back in operation.
4 | ||
Revision A (03/30/2005) | ||
|
