Jacuzzi EV77959 Before Installation, 1b 2b 2a 2c 3b 3a, Tools Needed, Alternate Mounting Hardware

Place Mounting Plate over mounting holes, flat side down, curve toward the back of the toilet.

Insert bolts through the Mounting Plate and finger tighten the wing nuts. Make sure the crush washer and metal flat washer are put on in the correct order (see

graphic).Crush Washer Metal Flat Washer

2

	Before Installation
Tools Needed
• Flat head screwdriver	• Universal wrench (included)
• Phillips head screwdriver	• Measuring tape

NOTE: The included Universal Wrench will work for most applications. Depending on your toilet configuration, an adjustable wrench may also be needed.

Alternate Mounting Hardware

Some toilets may not provide adequate access to the seat mounting holes preventing proper installation of the Standard Mounting Hardware.

In this case you will need to use the Alternate Mounting Hardware and follow the enclosed instructions.

Check Water Supply Line

Check the line that connects the toilet tank to the water shut-off valve. If it is rigid pipe, you may need to purchase a flexible hose to replace it before installing the Refresh Personal Hygiene System™. The length of the hose and the size of the connectors will vary.

Installation

CAUTION CAUTION

Please read these carefully before installing the Refresh Personal Hygiene System™.

Failure to do so could result in flooding, leaking, or damage to the Refresh Personal Hygiene System™.

1)Remove Toilet Seat

Steps may vary by type of seat.

a)Lift hinge covers and use a screwdriver to

remove the mounting bolts.	1a
b) Remove the toilet seat.
2) Turn OFF Water and Flush Toilet

You may wish to place a container under the tank to catch any leaking that could occur during installation.

a) Turn water valve OFF completely. If the water valve does not shut OFF completely, STOP. Repair the water shut-off valve before proceeding.

b)Flush the toilet to empty the tank.

c)Disconnect water supply line from toilet tank.

IMPORTANT: Do not continue without completing these steps! Failure to do so could result in flooding, leaking, or damage to the Refresh Personal Hygiene System™.

3) Install Mounting Plate

NOTE:These instructions are for Standard Mounting Hardware. See Alternate Mounting Hardware at the top of this page for further details.

a)

1b

2b

2a

2c

3b

3a

b)

Mounting Holes

EX93000 Refresh Installation Manual 10/06