Installation (continued)
8)Remote Control Installation
a)Identify a location for the Remote Control that is visible and reachable from the toilet and that does not obstruct the IR signal.
Depending on your wall type, you can install the screws directly or use anchor mounts (provided) as shown.
b) If you prefer to not drill holes in your wall, you may use double sided foam tape to adhere bracket to wall. In this case, make sure to choose a tape with an adhesive that will not damage wall upon removal.
9)Filling the Reservoir
a)Place a plastic sheet (not provided) over the seat. Sit on the Refresh to activate the seat switch. Press one of the wash functions on the Remote Control. The reservoir will begin to fill. It will take between 5 and 10 seconds for the reservoir to completely fill.
When the reservoir is full the wash wand will extend and begin to spray. Push STOP to cancel the wash function. Remove the plastic sheet and discard.
b)Your Refresh bidet seat is now ready for use! Refer to the Operation section of this manual for programming and operation instructions.
Troubleshooting
| Issue | Possible Causes | Solution | |
1 | Low water flow or | 1) Clogged filter | 1) Clean filter | |
pressure | 2) Twisted hose | 2) Straighten hose | ||
|
| 3) Household water pressure low | 3) Increase water pressure to Refresh | |
|
|
|
| |
2 | Nozzles do not function | 1) Nozzles are dirty | 1) Clean the nozzles | |
properly | 2) Clogged filter | 2) Clean the filters | ||
|
| 3) Water pressure is too low | 3) Adjust water pressure | |
3 | Nozzles fail to react | Nozzles are dirty | Clean nozzles | |
|
|
|
| |
4 | Washing feature does not | 1) User not properly seated | 1) Adjust your sitting position | |
work or fails to spray | 2) Seat switch is not contacting toilet | 2) Make sure the seat switch is contacting | ||
|
| fixture properly | toilet bowl rim (switch is in seat foot) | |
|
|
|
| |
5 | Product shuts OFF | 1) Washing time exceeding 5 minutes | 1) Repeat cleaning function | |
during use | 2) Power failure | 2) Check power and/or unplug the cord | ||
|
|
| to reset | |
|
|
|
| |
6 | Seat not heated | Seat temperature set to OFF | Reset heated seat temperature | |
|
|
|
| |
7 | Water not heating | Water temperature set to OFF | Reset heated water temperature | |
|
|
|
| |
8 | Water flow sporadic or | Pulsating / Spa mode activated | Reset to normal washing mode | |
inconsitent | ||||
|
|
| ||
|
|
|
| |
9 | Dryer not working | Dryer only operates when activated | Sit on Refresh to operate Dryer | |
|
| by weight of person on seat |
| |
|
|
|
|
4 | EX93000 Refresh Installation Manual 10/06 |
|