Suction Cover/Strainer Maintenance
Clean the suction cover/strainer of hair and debris when necessary. To do this, remove the center screw and detach the square cover. Clean the cover by backflush- ing debris from the holes. Replace the suction cover immediately after cleaning. When reinstalling, orient the cover/strainer with the small notch at the bottom. The gasket must be inserted into the groove of the cover/ strainer before reinstalling onto the suction fitting.
CAUTION: Keep hair a minimum of 6 inches away from the suction fitting at all times when the whirl- pool system is operating. Hair longer than shoul- der length should be secured close to the head. Do not operate the whirlpool system with the suction cover removed! It is a safety device and must al- ways be in place on the suction fitting to minimize the potential hazard of hair and body entrapment.
SUCTION COVER/STRAINER ASSEMBLY
COVER STRAINER
SUCTION
FITTING
SCREW
NOTCHGASKET
Lamp
When the bulb burns out, replace it from the back of the lamp fitting, on the underside of the shell, by pulling out the bulb receptacle. Replacement bulbs (7W, 12V) are available from your Jacuzzi Whirlpool Bath dealer.
LIGHT BULB REPLACEMENT
LOCKING NUT
LIGHT BULB
BULB RECEPTACLE
LIGHT BEZEL
SHELL
PRODUCT SPECIFICATIONS ARE SUBJECT TO CHANGE WITHOUT NOTICE.
USE INSTALLATION INSTRUCTIONS SUPPLIED WITH PRODUCT.
Jacuzzi Whirlpool Bath has obtained applicable code (standards) listings generally available on a national basis for products of this type. It is the responsibility of the installer/owner to determine specific local code compliance prior to installation of this product. Jacuzzi Whirlpool Bath makes no representation or warranty regarding, and will not be responsible for any code compliance.
Jacuzzi Whirlpool Bath
P.O. Box 702168, Dallas, TX
Service Support: Call (800)
©2000 Jacuzzi Whirlpool Bath S198000 8/16/04
Printed on Recycled Paper | Printed in the U.S.A. |
13
