CV-M2
- 26 -
7.1. Mode setting SW1 on rear
Switch SW 1.1 on the camera rear can be used to select digital or analogue video out. SW1.1 has
higher priority than RS-232C.
SW1.2 is for termination of the trigger 1 input on pin #10 Hirose.
(SW1.3 is for termination of the factory test input on pin #11 Hirose)
SW1.4 is for master gain selection. SW1.4 has higher priority than RS-232C.
Fine gain adjustment on R channel by RS-232C.
Gain
1
2
3
4
Trig 1 term.
Video out
RS-232 < > potm.
Digital < > Analog
TTL < > 75Ω
SW 1
Factory use
TTL < > 75Ω
Gain
1
2
3
4
Trig 1 term.
Video out
RS-232 < > potm.
Digital < > Analog
TTL < > 75Ω
SW 1
Factory use
TTL < > 75Ω
Fig. 30. SW1 on camera rear
7.2. RS-232C/Camera Link switch
The internal switch HR/CL can be used to select the control input via the 12 pin Hirose as RS-
232C or via Camera Link. Factory setting is Camera Link. The switch is placed inside the camera
on the motherboard.
1
2
Hirose < > Camera Link
< >
RS- 232C
NC
1
2
Hirose < > Camera Link
< >
RS- 232C
NC
Fig. 31. Internal Switch
7.3. Internal Switch
The switch is placed inside the camera on the motherboard.
SWSW
Fig. 32. Internal switch