Motion Sensor F.A.Q.’S
Q.I bought a new Sensor and the Control Center will not recognize it. Why?
A.First, make sure that the battery is new and has
been correctly attached to the terminals. Confirm that the Sensor has been correctly assigned to a Zone.
Q.I put the Sensor on Zone 4 and it will not set off the alarm. Why?
A.Zone 4 is a Dedicated Alert Zone and is designed to monitor Sensors in this Zone. It will only issue an alert (LED will flash, continuous beeping will be heard). Sensors in Zone 4 will not set off the alarm. Use Zone 4 for water Sensors, garage doors, gates, sheds or other areas you want to monitor (i.e. areas you want to be alerted if there is a problem, but do not want the alarm to sound).
Q.I erased a Sensor from a Zone and now all of my other Sensors in that Zone will not work. Why?
A.The system can only erase entire Zones. You will need to add the other Sensors back in that Zone to the Control Center again.
Q.I put the Sensor in a Zone (1, 2, 3) and it will not sound in any Alert modes. Why?
A.The Motion Sensor only functions as an Alarm Sensor in Zones 1, 2, 3. It will not activate a chime, visual or audio alert. An Alert in Zone 4 only, but will not activate the alarm.
Q.How can I tell if the Sensor is working?
A.Each Sensor has an LED that indicates the Sensor is operating (flashes when triggered). However if the battery is to weak, the signal may not reach the
12
