-To activate the Motion Sensor, press the Learn button located inside the battery compartment, or if mounted wave your hand in front of the Sensor (the red LED indicator will flash inside lens area in front of the Motion Sensor).
Testing a Sensor or your system
Once all the Sensors have been assigned to Zones in the Control Center you can now test your system.
|
|
| Step 2 |
|
| - | + | |
|
|
|
|
|
|
| Input DC 12V | |
|
|
| Select the Zone number |
| Mute | |||
|
|
|
|
|
|
|
| Learn |
|
|
| 1 | 2 | 3 4 | Arm |
| Alert |
|
|
|
|
|
|
|
| Chime |
1 | 2 | 3 | 4 |
| Armed | Power |
| Off |
|
|
| ||||||
Zone
Step 1
Press and hold the Learn button for three seconds
Step 3 Release the Zone button
Step 4
To activate the Motion Sensor press the button on the inside of the unit.
Ensure the Control Center can receive the signal from the intended location of the Sensor before permanently mounting a Sensor.
Step 1 - To place Control Center in Test mode unplug AC adapter and remove batteries.
Step 2 - Press and hold the ‘Mute’ button and plug the AC adapter back into the Control Center. When all the LED indicators turn on, release the Mute button. The Control Center is now in Test Mode and any Sensor can now be tested in any Zone.
